How to Build tric points yarn pattern
There are two methods to set the points in a pattern yarn knitting project. The thumb method uses a needle and tends to create a less visible border on your piece of knitting. The two needles method creates a firmer edge, less elastic but strong, suitable for the most delicate threads and which are subject to increased wear.
Before you start to assemble points, make a loop. To use this method let the length of wire about 4 times the desired width for your work. Fig. 1 Attach the free end of the yarn in your left hand and the needle in your right hand. Take a loop with the left thumb, putting it under the wire from the rear and move the thumbs up to form the loop. Fig. 2 Put the needle into the loop and hold the left thumb in place. Fig. 3 Insert the needle, from bottom to top, inside the wire that is around the thumb. Use the skein yarn in your right hand to wrap the yarn around the needle. Move the needle down so that the needle tip bring the wire that was in his right hand. Fig. 4 Loosen the thumb loop and pull with your left hand so that it is tight, thus forming the second mesh.
Fig. 5 Continue until you have all the necessary points. method of two needles Fig. 6 Make a loop and place it on the left-hand needle. Fig. 7 Pull the right hand needle through the loop, from the front. Wrap the wire needle clockwise. Fig. 8 Pull the loop through the mesh and place on needle. Continue until you have the necessary ties
